PaverAdhesive

Patent Pending

powered by FreeFind

Become a distributor of Paver Pieces!

Paver, Brick, and Wall Unit Adhesive

TYPE I Premium Grade Adhesive
	TYPE I- FLEXIBLE Excellent for bonding projects with freeze-thaw areas subject to stress or heavy loads. Apply to clean, dry, moisture-free sub-strate. If rain is expected, wait until there is at least 12 hours of curing time before any moisture. Adhesive is slow to set, so in warm weather allow 2-6 days. This adhesive should not be over applied. If it is too thick, it will take too long to cure or will not cure fully. Do not apply thicker than 1/2 inch. Usage: 3-4 linear feet of pavers or wall glue per tube. Bring material to room temperature if stiff from cold before using. Application range: 40 to 120 degrees F. Cleanup with toluene or xylene.
TYPE 2 Standard Grade Adhesive
	TYPE 2 - BasicBOND This is a great Standard Grade Adhesive. Perfect for non-critical areas like retaining wall caps or ornamental veneering. This adhesive must be applied to clean, dry, moisture-free sub-strate. It is fast to set, about 4-6 hours in warm weather. Wait 24 hours or overnight before traffic is allowed. Wait longer if below 55 degrees. Apply up to 1/2 inch thick. Usage: 3-4 linear feet of pavers or retaining wall per tube. Bring material to room temperature if stiff from cold before using. Application range: 30 to 110 degrees F. Cleanup with toluene or xylene.
TYPE 3 Super Premium Adhesive
	TYPE 3 - SuperWET Super Premium Adhesive. This adhesive can be applied to wet or saturated material so it is perfect for late season application. This is a great adhesive for step veneering and freeze-thaw areas. Great for areas subjected to heavy loads like step treads and pool coping. Usage: Type III adhesive foams during curing and will fill up to 1/4 inch. Allow 24 hours curing time before traffic is allowed. 75 percent strength in 24 hours, 95 percent strength in 48 hours. Substrate should be dust and dirt free. If extremely dry, spraying with water on surfaces before application will help adhesive cure properly. Application range: 35 degrees to 110 degrees F. Cleanup with mineral spirits before dry.

SAFETY PRECAUTIONS... When using Types 1 and 2 indoors, always supply plenty of ventilation. Caution: Flammable. Contains toluene and other petroleum distillates. Keep away from heat and open flame. Use only in a well-ventilated area. Keep out of the reach of children.

TYPE I - FLEXIBLE

Case of 10.3 oz tubes - $89.95

10.3 oz tubes - 12 tubes /case

Case Quantity

Case of 29 oz tubes - $155.95

29 oz tubes - 10 tubes /case

Case Quantity

TYPE 2 - BasicBOND

Case of 10.3 oz tubes - $49.95

10.3 oz tubes - 12 tubes /case

Case Quantity

Case of 29 oz tubes - $91.95

29 oz tubes - 12 tubes /case

Case Quantity

TYPE 3 - SuperWET

Case of 18 oz bottles - $117.95

18 oz bottles - 4 bottles /case

Quantity

|Home| |Photos| |Links| |Contact Us|

BeautiBrick, Inc. PO Box 970 Hampstead, NC 28443